Search:

Type: Posts; User: crakka

Search: Search took 0.00 seconds.

  1. What email address can I send to?

    What email address can I send to?
  2. Thanks for the recommendations. I have decided to...

    Thanks for the recommendations. I have decided to buy a new turbo, genuine identical part by Borg Warner. I'll change it out myself then see if the old one is worth salvaging for someone in need.
  3. Ok I understand that. I might even be able to try...

    Ok I understand that. I might even be able to try and sand-blast it as I have the grit and gun. Correct me if I'm wrong.
    Either way, I have to get the entire turbo with manifold off by the sounds of...
  4. Mate thanks for that quick isolation of the...

    Mate thanks for that quick isolation of the problem. I did wonder if it was a turbo wear issue. To clarify, do you mean a good clean out or a full rebuild?
    I noticed some gravelly winding sounds...
  5. Updating my situation. I wonder if anyone can...

    Updating my situation.

    I wonder if anyone can figure this one out.
    So I've gone through the Turbo Actuator syncing instructions about 4 times now. Each time I got it exact, after a drive or...
  6. OK I've checked for vacuum leakage but the...

    OK I've checked for vacuum leakage but the Actuator is perfect and the boost control solenoid only a few months old, so no issues there.
    I found on re-inspection that the voltage had altered to an...
  7. Cheers PJD83. I am not sure that I'm out of...

    Cheers PJD83.

    I am not sure that I'm out of the woods yet though. All seemed to be going fine until tonight we had to go out and the trip to the destination went well, whereas on the way back, the...
  8. All went well with the calibration. I noted the...

    All went well with the calibration. I noted the way those instructions were written it sounded like someone who wasn't perfect at English. Also it seemed a bit mixed up order at one point, as well as...
  9. Great thanks for the clarifications. I'm about to...

    Great thanks for the clarifications. I'm about to sit down to digest it now.
    I've made up a tool that can reach down and do the nuts. I have a basic vacuum pump kit that seems to work well to at...
  10. Thanks Phil. I got the PDF in my mail. I'll look...

    Thanks Phil. I got the PDF in my mail. I'll look through better tomorrow since now I've already mounted the actuator but it's throwing a coil light as I coudn't get the calibration right by guessing....
  11. Phil Thanks for replying. This is the third time...

    Phil Thanks for replying. This is the third time I've tried to reply, but I think my messages are getting moderated out for some strange reason. Dunno if I have been blocked.
    Anyhow if this works, I...
  12. Hi Phil, my apologies for the delay but I thought...

    Hi Phil, my apologies for the delay but I thought I'd replied already to this. My email address is crakka33@tpg.com.au
    I'd love to get those instructions on how to tune in the variable turbo...
  13. I'm not sure if you saw this before, but I would...

    I'm not sure if you saw this before, but I would appreciate the instructions you recieved from Crasher for your New Turbo synching.
    If anyone else has these, could you send them please?
    My Skoda is...
  14. Yes Please How can you send it to me? Email or...

    Yes Please How can you send it to me? Email or other way?
  15. I was interested in the procedures to Calibrate a...

    I was interested in the procedures to Calibrate a new Turbo Boost Control Position Sensor (Actuator) to my Skoda
    I have a 2008 Skoda Octavia 2.0L TDI VRS Wagon.
    I need the procedure to get the...
Results 1 to 15 of 15