Results 1 to 3 of 3

Thread: DPF woes.. again

  1. #1
    Junior Member
    Join Date
    Jul 2020
    Posts
    1
    Post Thanks / Like

    DPF woes.. again

    Evening all

    Just joined and purchased in the hope it solves my problem or someone can point me in the right direction.

    Got a 2010 Crafter 2.5 and which died of death and threw the filter warning up and went into limp home mode. its sitting at 140k miles and mostly town driving so just bit the bullet and bought a new DPF

    Did a scan before hand with a delphi system and got the following codes

    P2BA8 - NOx Emissions Exceeded: Reductant Injection Interruption( still there and cant clear
    P2BAC - NOx Emissions Exceeded: Deactivation of EGR still there and cant clear

    P20BAC reductant ,pressure too low
    P2458 Diesel particulate filter regeneration duration

    Changed the DPF and replaced the NOX sensor as it looked worse for wear but the light still on and still in limp home mode

    Did a search on the forums and reset the soot/ash to 1 a few times in the long adaptions block 16 but still the same

    thanks in advance



    Friday,17,July,2020,16:48:29:55440
    -- Windows Based VAG/VAS Emulator Running on Windows 10 x64
    Version: 20.4.1.0 (x64) HEX-V2 CB: 0.4508.4
    Data version: 20200331 DS317.0
    www.Ross-Tech.com
    VIN: WV1ZZZ2EZA60 License Plate:
    Chassis Type: 2E (2E - VW Crafter Panel Van (LT3 / 2006 > 2016))
    Scan: 01 91 92 93 94 95 96 97 98 99 9A 9B 9C 9D 9E 9F A0 A1 A2 A3
    B0 B1 B2 B3 B4 B5 B6 C1

    VIN: WV1ZZZ2EZA60
    -------------------------------------------------------------------------------
    Address 91: LT3 Engine Labels: Redir Fail!
    Part No SW: 076 906 022 N HW: 076 906 022 G
    Component: R5 2,5L EDC A0A0SG 9021
    Coding: 0003032
    Shop #: WSC 00374 210 91487
    VCID: 1E65D81A6CBA5CFB417-FFFE

    No Faults Found
    or DTCs not supported by controller
    or a communication error occurred
    No fault code found.
    -------------------------------------------------------------------------------
    Address 95: LT3 ESP
    Part No SW: 9069022800 HW: 0004460153
    Shop #: WSC 00117 555 00000
    ASAM Dataset: 3 4101
    ROD: CRFT_ESP_3_36946.rod (*)
    VCID: 04518A72EE96962B773-8050
    1 Fault Found:
    5106 - CAN: Signal outside temperature invalid
    MIL ON - Test Complete - Active/Stored

    -------------------------------------------------------------------------------
    Address 96: LT3 Instruments
    Part No SW: 9069024700 HW: 9069012000
    Shop #: WSC 00000 000 00000
    ASAM Dataset: 32 786
    ROD: CRFT_KOMBI_32_786.rod
    VCID: 05579776E5ACAF2360D-8050

    1 Fault Found:
    9214 - EOBD indicator light: Faulty
    Test Complete - Active/Stored


    Test Complete - Active/Stored
    90A4 - Outside Air Temperature Sensor (G17): Short to Plus
    Test Complete - Active/Stored

    -------------------------------------------------------------------------------

    Friday,17,July,2020,17:17:58:55440
    VCDS Release 20.4.1 (x64): Generic OBD2
    Mode 03: Emission related fault codes

    Address 7E8: 2 Faults Found:
    P2BA8 - NOx Emissions Exceeded: Reductant Injection Interruption
    P2BAC - NOx Emissions Exceeded: Deactivation of

    Code:
    Friday,17,July,2020,17:18:56:55440
    VCDS Release 20.4.1 (x64):  Generic OBD2
    Freeze Frame Data for address 7E8
        PID02 DTC that caused freeze frame data storage: P2BA8 
        PID04 Calculated load value: 27.1 % 
        PID05 Engine coolant temperature: 65 C 
        PID0B Intake Manifold Absolute Pressure: 116 kPa abs
        PID0C Engine RPM: 1701 /min 
        PID0D Vehicle speed: 77 km/h 
        PID0F Intake air temperature: 19 C 
        PID10 Mass Air Flow: 41.05 g/s 
        PID11 Throttle position sensor: 83.9 %
    
    
    Edit Post   Reply   Reply With Quote    [/RIGHT]

  2. #2
    Administrator Keithuk's Avatar
    Join Date
    Jun 2012
    Location
    Stoke on Trent
    Posts
    18,172
    Post Thanks / Like
    First posts normally go in introductions else you could get a free fix and we never see you again!!!

    Why the hell do members post using the stupid fonts/colours!!! it looks crap. Just use the default ones.

    Post edited.

    I won't post those error codes until I know if your stopping with this forum.
    2010 Golf GTD (170) CBBB, 5 Door, Shadow Blue (P6/D5Q), Transmission Code: KXZ, Flat Tyre Indicator, Basic Protection Pack + VCDS.


  3. #3
    Administrator Crasher's Avatar
    Join Date
    Apr 2006
    Location
    Nottingham, England
    Posts
    24,212
    Post Thanks / Like
    You have a problem with the Adblue injection system
    "I disapprove of what you say, but I will defend to the death your right to say it"

    Evelyn Beatrice Hall (28 September 1868 13 April 1956)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •